Sensormatic VM96 INS Betreibershandbuch PDF herunterladen (Seite 86)

5-4 View Manager 96 Operator’s Manual

been designated a general monitor, this would be indicated by “W1-2G” in

the lower right corner of that monitor. “W1” stands for “Workstation 1”;

“2G” stands for “monitor 2 (General)”. If the same monitor had been

designated an alarming monitor, that would be indicated by “W1-2A” in the

lower right corner of that monitor. “2A” stands for “monitor 2 (Alarming)”.

How Do You Know When an Alarm Occurs?

When your System Administrator initially programmed the Activities, each

Activity was routed to specific Workstations. These Workstations are the

ones that will be affected when the alarm is initiated. In other words, it will

be the T

OUCH TRACKERs that beep, the video and the operator messages that

appear on the alarming monitors, and the Activity that can be cleared via the

OUCH TRACKERs for those Workstations.

When an alarm comes in, you will see an alarm count indicator displayed on

the alarming monitors for the Workstation where the alarm was routed. The

alarm count indicator identifies the total number of alarms that are currently

active (for this Workstation).

Every Activity has a unique number associated with it. This number is called

the Activity number. This Activity number is displayed on the monitor

whenever its associated alarm is initiated. It remains on the monitor for as

long as the alarm is active. The Activity number is indicated by the

characters “A:X”, where X = the specific Activity number; this is displayed at

the bottom of the monitor.

When an alarm comes in, the alarm count indicator is displayed on all of the

alarming monitors in each of the affected Workstations. The Activity

number is displayed on the lowest numbered alarming monitor available in

each of the affected Workstations.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 121 122

Keine Kommentare

Sensormatic VM96 INS Betreibershandbuch Seite 86