Sensormatic SpeedDome Ultra IV Betreibershandbuch PDF herunterladen (Seite 32)

Alarms, Areas and Home Settings 4-5

• If you are finished making changes, press and hold Iris Close, then press Focus

Near or Focus Far to save your changes and exit the utility.

• If you want to make changes to other settings, use the Tilt control to move the

highlight bar to Exit, then press Focus Far. The Dome Configuration Menu

appears. Continue with What To Do Next on page 4-13.

Configuring Normal Input States

IMPORTANT

Certain controllers allow the normal input states for domes to be specified at

the controller. These controllers include VM96, AD matrices with AD2083-

02A code units or AD168 matrix with AD168CCM or AD2083-02A code

unit. Do not use both the dome configuration utility and the controller to

assign the normal input states. Use only the dome configuration utility or

the controller to the assign the normal input states.

When Configure Normal States is selected from the Alarm/Areas/Home screen, the

following is displayed:

CONFIGURE NORMAL STATES

EXIT

INPUT NO.

NORMAL STATE

OPEN

CLOSED

OPEN4

Figure Chapter 4 -3: Configure Normal States Screen

Use this screen to assign open or closed as the normal state for the dome inputs. When an

input state changes from normal to abnormal and an internal alarm action is associated with

the input, the alarm is triggered. The normal state is used by both internal alarms and

controller defined alarms.

This command is not supported with Manchester.

Highlight Bar:

Move with Tilt

control.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 75 76

Keine Kommentare

Sensormatic SpeedDome Ultra IV Betreibershandbuch Seite 32