Sensormatic SpeedDome Ultra IV Betreibershandbuch PDF herunterladen (Seite 58)

Language and Password Settings 6-5

3. Use the Pan / Tilt control to move the blinking highlight around the available characters.

When the correct character is highlighted, press Focus Far.

If you make a mistake, press Zoom In to move the cursor one space right or Zoom Out to

move the cursor one space left.

4. Repeat step 3 until the password is complete. When finished, move the highlight to

Continue, then press Focus Far.

5. You must successfully enter the password twice. Use the procedure in step 3 to enter the

password again. When finished, move the highlight to Continue, then press Focus Far.

Note: If the passwords do not match, you must start over. Return to step 3 and repeat the

procedure.

6. The Language/Password screen appears. Do one of the following:

• To enable the password, continue with Enabling or Disabling Password

Protection on page 6-5.

• If you want to change the language setting, refer to Selecting a Language on

page 6-2.

• If you are finished making changes, press and hold Iris Close, then press Focus

Near or Focus Far to save your changes and exit the utility.

• If you want to make changes to other settings, use the Tilt control to move the

highlight bar to Exit, then press Focus Far. The Dome Configuration Menu

appears. Continue with What To Do Next on page 6-6.

Enabling or Disabling Password Protection

Password protection must be enabled before passwords can be used.

1. Select Language/Password from the Dome Configuration Menu.

2. Use the Tilt control to move the highlight bar to Password Protection.

3. Press Zoom In or Zoom Out to change the setting.

• If you want to use a password to prevent unauthorized use of the dome

configuration utility, select On.

• If you do not want to use a password, select Off.

The default setting is Off.

4. Do one of the following:

• If you want to change the language setting, refer to Selecting a Language on

page 6-2.

• If you want to set or change the password, refer to Setting or Changing the Dome

Password on page 6-4.

• If you are finished making changes, press and hold Iris Close, then press Focus

Near or Focus Far to save your changes and exit the utility.

• If you want to make changes to other settings, use the Tilt control to move the

highlight bar to Exit, then press Focus Far. The Dome Configuration Menu

appears. Continue with What To Do Next on page 6-6.

This command is not supported with Manchester.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 75 76

Keine Kommentare

Sensormatic SpeedDome Ultra IV Betreibershandbuch Seite 58