Sensormatic Intellex Betriebsanleitung PDF herunterladen (Seite 30)

Installation and Operating Instructions

14 Installation

7. Network — This RJ-45 connector connects the unit to a local area network. The

unit supports 10BASE-T (10Mbps) and 100BASE-TX (100Mbps) network

operation.

8. Audio Connectors — These are 3.5mm audio jacks to connect audio

input/output.

Blue Line In

Green Line Out (Speakers)

Pink Mic In (Microphone)

9. Com2 — This DB9-P connector provides the interface between the unit and a

dome controller (Sensormatic VM16 or American Dynamics ADTT16).

10. Printer — This DB25-S connector provides the interface between the unit and the

printer.

11. VGA OUT — This HD15-S VGA connector provides an SVGA signal to the Main

(SVGA) Monitor to display camera images and system status.

12. Camera In — Each BNC connector inputs video. The connector accepts the

composite video output of color or B&W cameras.

13. Alarms — These connectors accept up to 8 alarm inputs and 8 alarm outputs.

NOTE: The Time Sync Signal (Alarm In 17) is used to reset the system time of the

Intellex to the nearest hour. If the Intellex system time is up to 30 minutes

before the hour, the system time is set forward to the next hour (at zero

minutes and zero seconds). If the Intellex system time is up to 30 minutes

after the hour, the system time is set back to the previous hour (at zero

minutes and zero seconds).

NOTE: The Export Signal input (Alarm In 18) can be used to start a Fill CD operation

without access to the normal user interface. A contact closure, e.g., an

external switch, can be used to execute the Fill CD command to export the

last 500 MB of data to a CD. See Selective Export on page 160.

14. Video Out — This BNC connector provides a composite video signal of the live

display to an optional live monitor.

15. Camera termination switches — The termination switches are above each

camera’s BNC connector.

CAUTION: If you set the termination switch at 75 Ohms, you MUST select “Hi-Z”

in the Intellex Setup Options screen. If you select “75 Ohms” in the

Intellex Setup Options screen, you MUST use the “infinity” symbol

setting on the termination switch (see Cameras Option on page 64).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 237 238

Keine Kommentare

Sensormatic Intellex Betriebsanleitung Seite 30